INSTALLATION MANUALBEFORE INSTALLING THIS PRODUCT PLEASE READTHIS INSTALLATION MANUAL THOROUGHLY!!SECURITY SYSTEM W/ BUILT-INREMOTE AUTO START This sy
10ProblemAlarm will not go into Code LearningMode.Alarm will not rearm or will not pas-sively arm.Flashing light output does not work.Door locks do no
11POSITIVE TRIGGER DOOR LOCK CIRCUIT:REVERSE POLARITY (ADDING ACTUATORS):REVERSE POLARITY USING FACTORY SYSTEMS:GROUNDGREEN WIREFROM ALARMGROUNDBLUE W
12© 2001, DLC, INC.64-130, 10/01 Rev. 2
2Before you begin the installation:• Verify that the vehicle is equipped withelectronic fuel injection.• Verify that the vehicle is equipped with anau
3Main Harness:• WHITE WIRE - Parking light output (+).Connect to the wire that switches to +12Vwhen the parking lights are turned on. If thevehicle’s
43-Pin Red Connector: Plug-in connector portfor optional features harness.• GREEN/BLACK WIRE - 3rd channel output (-).Connect to a relay for optional
5Remote Programmable FeaturesTo enter program mode:1. Turn ignition to the on position.2. Wait 2 seconds.3. Within 10 seconds press program switch 5ti
6Default ResetTo reset all programmable features to their fac-tory default settings:1. Turn ignition to the on position.2. Wait 2 seconds.3. Within 10
7Bypassing Factory Theft DeterrentSystemsMany newer vehicles are now factory-equippedwith anti-theft systems that use either a resistorcoded key or a
8FIGURE 1. OPTIONAL VACUUMSWITCH INSTALLATIONVACUUMSWITCHEXISTING CARVACUUM HOSEYELLOW WIRE(VACUUM SWITCHINPUT ON MAIN UNITGROUNDEXISTING CARVACUUM HO
9ProblemUnit will not operate.Keyless Entry features operatebut vehicle will not start.Vehicle will not remote start.Engine cranks but not longenough
Comments to this Manuals